Where this service usually fits
- Bathroom remodels and additions
- GFCI protection for receptacles
- Ventilation fan circuits, timers and humidity controls
- Heated floor systems and their controls
- Vanity, shower and recessed lighting rated for damp or wet locations
What moves the price
How the numbers add up: how electrical pricing works
| Cost driver | Why it changes the number | Ask the electrician |
|---|---|---|
| Heated floor | Electric floor heating is a continuous load with its own control and protection requirements, and it usually means a dedicated circuit. | Is a heated floor in scope, and what wattage? |
| Layout change | Moving the vanity, bath or shower changes what is permitted where, because fixture proximity governs placement. | Is the layout changing? |
| Existing circuit sharing | Older bathrooms often share a circuit with bedrooms or a hallway, which current requirements generally do not permit for altered work. | What does the existing bathroom circuit serve? |
| Fan specification and duct route | A larger or quieter fan, a humidity-sensing control, or a long duct run each change the work. | Which fan and control are specified? |
| Fixture ratings | Fixtures near a bath or shower must be listed for damp or wet locations, which narrows the choice and can affect cost. | Are the chosen fixtures rated for their locations? |
| Access above the ceiling | Fan and light installation is far easier with attic access above than in a ceiling with a room over it. | What access is assumed for the fan? |
Information that changes the scope
- Whether a heated floor is planned and its wattage
- Existing circuit serving the bathroom and what else is on it
- Fan specification, duct route and control type
- Fixture locations relative to the bath or shower
- Whether the layout is changing
What a bathroom electrical quote usually includes
- Bathroom receptacle circuits with required protection
- Ventilation fan circuit, control and timer wiring
- Lighting rated for the location
- Heated floor circuit and control wiring where quoted
- Rough-in and finish device installation
What is usually NOT included
- Fixtures, fans and heated floor systems unless an allowance is stated
- Duct routing and exterior termination for ventilation
- Tiling, including setting heated floor cable in mortar
- Plumbing and any fixture relocation
- Wall and ceiling repair after access
Permits, inspection and code
Bathrooms have specific requirements: ground-fault protection for receptacles, dedicated circuit provisions, and fixture ratings determined by proximity to the bath or shower. Ventilation is generally required for a bathroom without adequate natural ventilation, and electric floor heating carries its own protection and control requirements.
Timing and scheduling in Vermont
Rough-in before tiling, and heated floor cable must be set during tiling rather than after. That makes the electrical and tiling schedules interdependent, and it is the commonest coordination failure in a bathroom remodel.
What a clear estimate should address
Separate rough-in from finish, and identify who supplies the fan, heated floor system and fixtures. Heated floor systems in particular are frequently supplied by the tiling contractor but connected by the electrician.